Male push-on terminals without insulation

Flat plugs are electrical connectors. They consist of a flat metal part that is inserted into a matching blade receptacle to create an electrical connection.

We offer you a large selection of

• uninsulated blade terminals and insulated blade terminals,
• blade terminals for screwing on,
• angled blade terminals for screwing on
• and spade connectors for solderingmade of hot-dip tinned brass.

Nickel-plated, silver-plated, gold-plated or tin-plated blade receptacles are also available on request - please contact us.

All of the blade receptacles and blade plugs we offer fit into each other, provided the mating width and mating thickness of both items match.

Three dimensions are generally important to clearly identify the right product:

• Cross-section in mm² - This is required for the insertion of the cable at the rear end.
• Mating thickness in mm - This is the thickness of the flat mating contact. The standard thicknesses are 0.5 mm and 0.8 mm.
• Mating width in mm - This is the distance between the two sleeve walls (also the width of the corresponding mating contact). The standard widths are 2.8 mm, 4.8 mm and 6.3 mm.

Many of our blade terminals comply with specific DIN standards. Please refer to the product detail page for the relevant DIN standard.

Standard blade terminals

Our uninsulated blade terminalsare available in dimensions in accordance with DIN 46343 Part 3, DIN 46248 Part 3 and DIN 46244. Made of brass, we offer them with a bare surface (abbreviation: MS) or galvanically tin-plated surface (abbreviation: VZ). Some items are also available in rolls (abbreviation: R).

• DIN 46343 Part 3, DIN 46248 Part 3 and DIN 46244
• made of brass
• available bright (MS) or with galvanized tin-plated surface (VZ)
• Some also available in rolls (R)

Angled blade terminals for screwing on

Our uninsulated, angled blade terminals for screwing on are available in dimensions according to DIN 46342, part 1 and similar versions. The dimensions are in the DIN 46244 mating range and the surface is tin-plated.

These blade terminals are used when there are special spatial requirements or a lack of space.

• Angled for screwing on
• DIN 46342, part 1 and similar versions
• Dimensions in mating area DIN 46244
• made of brass
• available with galvanically tin-plated surface (VZ)

Screw-on blade terminals

The dimensions of our uninsulated screw-on blade terminals comply with DIN 46244. They are made of brass and are available with a bare (abbreviation: MS) or tin-plated surface.

These blade terminals are used to create a secure and permanent connection between cables, wires and other electronic components.

• For screwing on
• Dimensions in mating area DIN 46244
• made of brass
• available bare (MS) or with a tin-plated surface (VZ)

Spade connectors for soldering

Our uninsulated blade terminals for soldering in printed circuits correspond to the dimensions of DIN 46244. They are also made of brass and are available in a hot-dip tinned version.

Our blade terminals for soldering are available in various sizes and designs. They are mainly used for connecting printed circuit boards in electronic devices and switchgear.

• For soldering into printed circuits
• Dimensions in mating area DIN 46244
• made of brass
• available with hot-dip tinned surface (VZ)